Knowledge is power, power is useful when you are stimming

Stainless Steel Glans Electrodes

Product applicability

Product Type Jet Set Willy, Helmet, Pit Helmet and Hard Hat
SKU Codes

Materials And Design

These monopole electrodes are made from 3D-printed 316L Stainless Steel.

This process allows us to create impossible shapes that other manufacturing techniques cannot.

The Helmet and Pit Helmet electrodes have a stretch, non-slip velcro strap to secure them.

The Jet Set Willy and Pit Helmet electrodes have multiple ways to connect to them.

They can all be used as a common electrode in a tri-phase configuration, but ensure that both plugs from a channel are not plugged into the same electrode, as that can cause a short and possibly damage your e-stim control box.

General Safety Considerations

DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART (FRONT TO BACK, OR SIDE TO SIDE), CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER OR OTHER ELECTRONIC MEDICAL IMPLANT, ARE EPILEPTIC, OR ARE, OR MAYBE PREGNANT. REMEMBER YOU USE THIS DEVICE AT YOUR OWN RISK.

Instructions For Use

Fitting

You must ensure that your control box is switched off and the power level knobs are set to their minimum position before fitting electrodes! The glans electrodes are monopole electrodes, meaning you must use them with another electrode to complete a circuit.

Each electrode has different connection options. Connect one wire from a channel to the electrode, and use a second electrode on the same channel to form a circuit.

  1. Connect one of your cable plugs to your glans electrode and the other to a separate electrode.
  2. Apply conductive gel/lube to the underside contact surface that touches your skin.
  3. Fit the electrodes in place. The elasticated strap can hold the Helmet or Pit Helmet in place. Other ways to secure these electrodes in place are: Rolling a condom over the top of them or using medical cohesive bandages over the top to ensure a snug fit.
  4. Turn on your control box and adjust your controls.
  5. Enjoy and adjust the fit of your electrode during the session if required.

 Removal

  1. Ensure the output of your control box is set to zero, and ideally, switch off the control box before removing your electrodes.
  2. Unplug your cable, loosen your electrode strap and remove it.
  3. Wipe down the electrode to remove excess conductive gel. Clean before storing for the next session.

Cleaning

Wash the electrode in warm, soapy water and dry it before storing it until your next session. Do not use abrasive or caustic materials on the conductive rubber components.