Knowledge is power, power is useful when you are stimming

Ball Stretcher & Crusher Electrode

Product applicability

Product Type Ball Stretcher/Crusher Electrode
SKU Codes 40096

Materials And Design

This stretcher crusher electrode is made from ABS and conductive rubber. It has three conductive rubber loops that can be used as electrode surfaces.

It is designed to apply a stretching and clamping force to the testicles while also acting as electrodes, with three contact surfaces.

The top features a crush plate with two conductive rubber loops on the underside and spikes on the top. It can be removed and fitted in either orientation to provide the desired crushing style.

The lower base loop carries a 6mm conductive rubber loop.

The yellow crush plate carries two lengths of 6mm conductive rubber that can be used as electrode surfaces.

The middle plate features an arm that can swing open when the red latch is operated. This latch can be padlocked closed.

General Safety Considerations

DO NOT CONNECT ANY ELECTRICAL DEVICE TO ANY LOCATION ABOVE THE WAIST (ACROSS THE ARMS COUNTS AS ABOVE THE WAIST!), BUT ESPECIALLY DO NOT CONNECT ACROSS THE HEART (FRONT TO BACK, OR SIDE TO SIDE), CHEST, NECK OR HEAD. DO NOT USE IF FITTED WITH A PACEMAKER OR OTHER ELECTRONIC MEDICAL IMPLANT, ARE EPILEPTIC, OR ARE, OR MAYBE PREGNANT. REMEMBER YOU USE THIS DEVICE AT YOUR OWN RISK.

THIS CLAMPING ELECTRODE IS CAPABLE OF CAUSING INJURY IF NOT HANDLED CORRECTLY. CARE SHOULD BE SHOWN WHEN USING IT. FAMILIARISE YOURSELF WITH HOW TO RELEASER THE CLAMPING FORCES BEFORE USE

Instructions For Use

Fitting

You must ensure that your control box is switched off and the power level knobs are set to their minimum position before fitting electrodes! Each piece of conductive rubber is an electrode.

Each electrode has different connection options. Connect one wire from a channel to the electrode, and use a second electrode on the same channel to form a circuit.

  1. Connect one of your cable plugs to one of your electrode loops, and the other to another loop.
  2. Remove the two black thread protectors upper black nut holders, then the top plate can be removed.
  3. Then lower the middle plate. Operate the red latch and swing the arm open.
  4. Apply conductive gel/lube to the underside contact surface that touches your skin.
  5. Insert the scrotum and testicles through the lower and middle plates. Tighten the conductive rubber loop to prevent the testicles from migrating upwards. Close the locking arm carefully, ensuring the testicles in the scrotum end up above the plate. This plate can then be moved using the black nut holders to stretch the scrotum. Once the desired stretch is achieved, fit the top plate and secure it with the two nut holders. Refit the bolt thread protection caps.
  6. You can adjust the stretch and crushing using the black nut holders to raise or lower the middle and upper plates.
  7. Turn on your control box and adjust your controls.
  8. Enjoy and adjust the fit of your electrode during the session if required.

 Removal

  1. Ensure the output of your control box is set to zero, and ideally, switch off the control box before removing your electrodes.
  2. Unplug your cable, raise the upper crushing plate using the two upper black nut holders, then remove the plate.
  3. Operate the red latch and swing the locking arm open.
  4. Release the lower conductive rubber loop and remove the electrode. Clean before storing for the next session.

Cleaning

Wash the electrode in warm, soapy water and dry it before storing it until your next session. Do not use abrasive or caustic materials on the conductive rubber components.